Show simple item record

dc.contributor.authorNamara, Florence
dc.date.accessioned2017-09-13T01:18:57Z
dc.date.available2017-09-13T01:18:57Z
dc.date.issued2015-10
dc.identifier.citationNamara, F. (2015). Evaluation of the quality of reinforcing steel bars manufactured in Uganda. Unpublished masters dissertation. Makerere University, Kampala, Ugandaen_US
dc.identifier.urihttp://hdl.handle.net/10570/5710
dc.descriptionA thesis submitted in partial fulfillment of the requirements for the award of the Masters of Science Degree in Mechanical Engineering of Makerere Universityen_US
dc.description.abstractTo apply locally manufactured steel bars in all engineering applications with confidence requires understanding of structural materials properties beyond commercial standards to ensure that they meet demands of the fundamental assumptions underlying structural codes of practice on which designs are based. At present, there is inadequate information on the actual behaviorof reinforcing steel bars which are used forconstruction in Uganda. This research therefore intends to generate information concerning the physical properties of reinforcement bars in relation to production practices. The researcher used the qualitative and quantitative methods to investigate the problem. Two types of reinforcement steel bars were studied; conventional cold twisted deformed (CTD) high yield bars and thermo-mechanically treated (TMT) bars made from scrap as the raw material. Steel bars of 12mm and 16mm nominal diameters were considered in the study. This dissertation presents a description of the production process and experimental (Tensile test and chemical analysis) investigations carried out on the steel bars. The chemical analysis indicates lack of control of the chemical composition in some samples, with the carbon content ranging between 0.237 and 0.33, an indication that same samples contain very high carbon levels above 0.27% as recommended by the US 155-1: 2004. The primary observations made with the physical properties are that, the characteristic tensile strength is abovethe (460*10-3N/m2) value recommended by the US. Elongation is also significantly high except for a few sampleswhich are just at the threshold. The few cases with low elongation may lead to limited ductility of the steel reinforcement bars. Improvements in the scrap sorting practices and Production process are suggested in order toattain better quality.en_US
dc.language.isoenen_US
dc.publisherMakerere Universityen_US
dc.subjectSteel barsen_US
dc.subjectConstruction materialsen_US
dc.subjectEnginnering worksen_US
dc.subjectReinforcement baren_US
dc.titleEvaluation of the quality of reinforcing steel bars manufactured in Ugandaen_US
dc.typeThesis/Dissertation (Masters)en_US


Files in this item

Thumbnail
Thumbnail

This item appears in the following Collection(s)

Show simple item record